V operacijah z laserskim varjenjem je rdeča luč, ki ni osredotočena
1. Manifestacija napak
During the laser welding process, the red light that should accurately indicate the welding position deviates, and the projected light spot is not on the predetermined welding track. This makes it difficult for the operator to accurately judge the welding position, resulting in welding deviation, which ultimately affects the quality of the finished welded product and may even cause the welded part to be scrapped in severe cases.
2. Analiza vzrokov
1. Manifestacija napak:
During the laser welding process, the red light that should accurately indicate the welding position deviates, and the projected light spot is not on the predetermined welding track. This makes it difficult for the operator to accurately judge the welding position, resulting in welding deviation, which ultimately affects the quality of the finished welded product and may even cause the welded part to be scrapped in severe cases.
2. netočna kalibracija rdeče luči:
Ko je oprema prvič nameščena ali po vzdrževanju, če rdeča luč ni natančno umerjena in rdeča luč in laserski žarek ne bi zagotovila koaksialne, potem med dejanskim varjenjem rdeča luč odstopa od položaja varjenja in ne bo mogla odigrana vloga natančne indikacije .
3. rešitev
1. Preverite in prilagodite optično pot: previdno preverite vsako optično komponento na optični poti in preverite, ali obstaja kakšna ohlapnost ali premik . za ohlapne komponente jih zategnite; Za komponente Offset uporabite profesionalna orodja za natančne prilagoditve, da zagotovite, da so optične komponente strogo poravnane, tako da se lahko rdeča luč širi po pravilni optični poti .
{{0 {
Nasveti
{{0 {
{{0 {
Nj
